Just purchased a RCBS Case Master. Perhaps a little fiddly to set up but I am sure that wil change with practise.
So far on a random selection of my reloads with used cases 222/25/06/7x57/308
Case neck run out, all very good mostly under 0.002"
Case Neck thickness, again very good mostly under 0.002"
Case head [FONT="][/FONT]separation, excellent
Bullet run out, appalling often up to 0.01"
I use Hornady New Dimension/RCBS/LEE die so either I am ham fisted with bullet seating or my press a Wamadet is way out of alignment.
I will be undertaking more test next time I reload, what is your experience of this tool?
So far on a random selection of my reloads with used cases 222/25/06/7x57/308
Case neck run out, all very good mostly under 0.002"
Case Neck thickness, again very good mostly under 0.002"
Case head [FONT="][/FONT]separation, excellent
Bullet run out, appalling often up to 0.01"
I use Hornady New Dimension/RCBS/LEE die so either I am ham fisted with bullet seating or my press a Wamadet is way out of alignment.
I will be undertaking more test next time I reload, what is your experience of this tool?