CZ 455 Trigger kit

garyb

Well-Known Member
Has anyone here fitted a trigger kit to a new CZ455 rimfire?

Having an issue and could do with running a question by someone that has.
 
Did you remove the sear ball bearing or not?

The instructions are all for 452 actions

And how did you put it back?
 
Did you remove the sear ball bearing or not?

The instructions are all for 452 actions

And how did you put it back?


I ahev fitted a kit on a 452. If its the same then NOOOOO do not touch the sear ball. For the 452 you knock out the pin on the opposite side to the sear pin slide the required ring over the pin and then refit with the requried spring. If you do need to take the ball out then make sure you cover it somehow because Ive heard they shoot out.
 
I ahev fitted a kit on a 452. If its the same then NOOOOO do not touch the sear ball. For the 452 you knock out the pin on the opposite side to the sear pin slide the required ring over the pin and then refit with the requried spring. If you do need to take the ball out then make sure you cover it somehow because Ive heard they shoot out.

Same here! I used a 'YoDave' kit, which requires the removal of 2 pins, one of which is replaced with the substitute part supplied.

ATB

T
 
Back
Top