Hi all, just bought a new set of warne QD 30mm scope mounts for my new duralyt scope. Mounted the rings using the method outlined by warne ie torque the lower bolts to 25 inch/lbs then finally make small movements to position scope. Once done the torque top bolts to same torque settings. I have even bought the dedicated torgue wrench to make sure i got it right! (sad I know but beer and internet shopping is a bad thing!!!)
Imagine horror when found that one of the mounts had marked the paint on the top of the scope where it joins together. Now have new scope with 2 marks on the top of it where these mounts have left a mark.
Has anyone else had this issue with the warne scope rings ?