I'd be surprised if they are not metric, as the rifle is made in Japan.
They may well be an in-between size though, and a fine thread rather than standard.
I'd be surprised if they are not metric, as the rifle is made in Japan.
They may well be an in-between size though, and a fine thread rather than standard.
The problem i have is with a set of warne weaver base is the screws supplied only protrude from the base buy at most 2-3 threads at most
So they are not going to hold very well and probably just strip the threads in the receiver if you tried to tighten them
Ok, I just dragged out the X-Bolt rings and bases I have for sale on here.
Back of the pack says base screws are either 6-48 or 8-40.
EDIT: Ok just measured and googled them, they are 6-48, and the ones with my bases and rings measure
.264" x 4 off and .290" x 4 off for the thread length, so different size screws are needed.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.