FREE To Enter Competition..................

[steve19]

All depends on your printer settings.

I'm guessing 58 and 86.

 

[rollotomassi]

285 minutes and 345 minutes

 

[Lateral]

All depends on your printer settings.

I'm guessing 58 and 86.

Steve,

It's not a trick question, I WANT people to win the prizes !

But, I've taken the time from a file I use regularly, using saved printer settings for my magnetic moderator holder.

I've based it on a common size, with the emphasis on a nice clean finish, rather than how fast I can print them.

This is just a bit of fun, and the "time", is just a means to an end


Mark

 

[Cannon]

21 minutes or

32 minutes

 

[John Gryphon]

4hrs 14 mins

 

[slider]

2 hours and 3 minutes

2 hours 13 minutes

 

[Blench99]

135mins, cheers

 

[Bo Diddley]

73 minutes

96 minutes

Great offer.

 

[finnbear270]

Ok, you were right, you have NO idea

Maybe try the next one

 

[WalkedUp]

In work this would be an overnight print (at much lower quality) so I will say between a Laupa Magnum and a Creedmoor, in minutes and hours respectively.

 

[Donnington]

130 mins

 

[AJC]

33 minutes

 

[wilbert]

39 minutes and 47 minutes

 

[Stimo444]

46 minutes

 

[wytonpjs]

From my resident SME, between 58 minutes and 144 minutes dependent upon printer settings, requirements, material, etc

 

[Lateral]

From my resident SME, between 58 minutes and 144 minutes dependent upon printer settings, requirements, material, etc

And just what two times would you like to choose between 58, & 144 minutes, or are you hoping to claim each minute between the two

The only people who comment on the print settings, either have a printer, or have some idea of 3D printing, but I can tell you from the answers so far, IT'S NOT HELPING

 

[bbell]

I am going to say 185 minutes

 

[Mike1979]

136 minutes and 204 minutes

Havent got a clue but fun nonetheless

 

[wytonpjs]

And just what two times would you like to choose between 58, & 144 minutes, or are you hoping to claim each minute between the two

The only people who comment on the print settings, either have a printer, or have some idea of 3D printing, but I can tell you from the answers so far, IT'S NOT HELPING

How long is a piece of string Mark..............

On my teenager's advice, I'll go 60 minutes and 90 minutes

 

[Zephyrjim]

Lets have a go then....Great little competition and thanks for putting it up
223 minutes
243 minutes