-
-
deeangeo replied to the thread .25-06 opinions.Mine’s a 22” barrel & works perfectly well. There’s a slightly lower MV, but for me 3100fps with a 110gn AB bullet works just fine. I... -
I’ve got eight Steyr Mannlicher Schoenauer stutzen carbines but the newest was made in 1965 I believe so my comments are worthless to...
-
deeangeo replied to the thread .25-06 opinions.Recoil from .25-06 is pretty gentle in my opinion when compared to .308 But then I use the 110gn AB bullet, so rather lighter than the...
-
Just the progress made since 1950 in the British educational system 😜
-
Not possible
-
This is the ding it gets when the neck hits the receiver after being extracted from the chamber. A bit extreme though. Seems to have a...
-
I’ve done the gamut of 25’s . 250 Savage , 257 Bob , 25-06 and 257 Weatherby . All of them make pretty fair deer rifles . However of the...
-
deeangeo replied to the thread .25-06 opinions.What's to say here! I've used my current .25-06 for 20 years... in the hills of the Highlands, Galloway, England - it does every species...
-
-
deeangeo replied to the thread 25-06 or 6.5 creedmoor.For some reason it's not a fashionable cartridge... no idea why! It's a cartridge that takes all UK quarry with authority. It's a...
-
deeangeo replied to the thread What squares a die? The shell holder or the lock ring?.Try it & see is my suggestion. Measuring the case neck to body run out after setting up this way does produce very low run out. Usually...
-
deeangeo replied to the thread What squares a die? The shell holder or the lock ring?.It's Cool, - whatever works for you best. Personally, I never tried leaving the de-cap rod/mandrel loose. Maybe I should! For me, I see...
-
deeangeo reacted to Stalker-of-the-deer's post in the thread What squares a die? The shell holder or the lock ring? with
Like.
For concentricity you actually want the die to float so it centers properly on the case. If you have a forster co ax it does it by... -
deeangeo reacted to Ronin's post in the thread What squares a die? The shell holder or the lock ring? with Like.
The smart way to resolve the stress inducing issue of lock ring and none concentricity of one’s dies ………………is to place a “O” ring...
-
deeangeo replied to the thread What squares a die? The shell holder or the lock ring?.Good advice & works well! The cartridge case/neck can also be centred in the sizing die by slackening the decap/mandrel rod & driving a...
-
When I read "neck tension" immediately Albert Pierrepoint came to mind. Dunno why.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
