Tikka Ace target users

Tikkat1x

Well-Known Member
anyone using one with a bag rider?
which one are you using? iv seen a couple that look ok, one i cant find, the other i can but seems out of stock everywhere,
and also have you stuck with the supplied thumb rest or gone for a more traditional flatter version,
bag rider wise id rather the one in the first picture if i could find one
 

Attachments

  • t3x_ace_target_galleria4-768x512.webp
    t3x_ace_target_galleria4-768x512.webp
    28.5 KB · Views: 68
  • tikkat3x01.webp
    tikkat3x01.webp
    33.2 KB · Views: 67
  • OIP (1).webp
    OIP (1).webp
    5 KB · Views: 55
  • OIP (2).webp
    OIP (2).webp
    1.4 KB · Views: 67
I’ve got a factory Tikka bag rider and am happy with it. I did also buy a 3D printed one off eBay but it was a bit small for me. Standard thumb rest too, feel fine to me. Try Livens for the accessories.
 
Bought the ones that are 3D printed off here, fitted and look good. What bullet/powder load are those with a 6.5 Creed using, about to work up some loads.
my last CM i used sierra 130gr TMK's and Hornady 140gr ELD-M's to good effect, both with N555, half MOA if not better when i did my bit right,
but this time round im going to start wit N160 as i have loads,

who does the printing on here??

thanks.

Lee
 
Shooter 123 3d printing...
thanks. iv actually had some butt spacer off him before, sadly hes on my ignore list as when i go in the sales section the first 92 pages were all his bits :lol:
found them on ebay yesterday, i will get one till i can find a proper one👍
i also have a plan to get someone to machine me a bar to make it more like the MDT Acc elite, if possible:D
until such a time i can justify buying one, PD_ACCEliteChassisSystem_03__09110.webp
 
Back
Top