Results 1 to 3 of 3

Thread: Help with Reloader powders 10X and 22 for .223 and 30.06

  1. #1

    Help with Reloader powders 10X and 22 for .223 and 30.06

    Hi guys. Has anyone got any good recipes/weights for these?

    The 10x is going to be pushing 50 grain hollow point heads out my .223.

    The 22 is pushing 180 grain soft points out my 30.06

    thanks

    Luke

  2. #2
    You do know that the Alliant site has "recipes" for different powders and loads, right? These are a single recommended load for each powder. I think 24.2 grains (?) is for 10X and 50 grain bullet. Check them out.~Muir

  3. #3
    RL-22 is a bit slow for anything below 190 grains.

    Because of variations in brass volume and bullet bearing surface, you will have to start at 57.5 gr and work up towards 60 gr MAX ( 2,700 fps from a 24-inch barrel ).
    You may have to stop at 58.0, or find it is the most accurate load. You need a chronograph to check it.

Similar Threads

  1. Reloader 22 for 25.06.
    By carolgee56 in forum Rifles & Calibres
    Replies: 19
    Last Post: 12-06-2017, 15:58
  2. *SOLD* Reloader 10x
    By Colonel in forum Reloading
    Replies: 3
    Last Post: 24-04-2015, 20:33
  3. dies wanted .223, 25-06, 30-06
    By Offroad Gary in forum Reloading
    Replies: 5
    Last Post: 13-04-2013, 23:38
  4. Short barrel (50cm) 30-06, powders and opinions?
    By Jonher in forum Ammunition, Reloading & Ballistics
    Replies: 14
    Last Post: 07-05-2011, 22:03
  5. reloader 22 for 25/06 reloads.
    By jay 22 in forum Ammunition, Reloading & Ballistics
    Replies: 6
    Last Post: 25-04-2011, 23:59

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •