Page 1 of 2 12 LastLast
Results 1 to 10 of 11

Thread: .20 cal rod/jag/brush what do you use?

  1. #1

    .20 cal rod/jag/brush what do you use?

    Looking to buy a rod and jag/brush etc for my .204, anyone recommend anything?

  2. #2

  3. #3
    Tipton carbon fibre or Dewey rods with Dewey jags and brushes (The jags and brushes are cheaper in bulk from direct from Dewey), Pro-Shot patches.


    Cheers

    Fizz

  4. #4
    Cheers Fizz, i'll take a look at them , also the proshot ones - cheers lads.

  5. #5
    You will find everything you will need here http://www.riflecraft.co.uk/rifles/r...nance-100.aspx
    Proof positive jags and brushes are a godsend too.

  6. #6
    Thanks, i'll have a look at the website.

  7. #7
    I use the pro shot stuff, its not coated but what i did was buy to some heat shrink from ebay. I can replace it s when dirty and also slide it up over the shaft of the jag and brush to protect the crown when scrubbing

  8. #8
    Good tip, cheers, been looking at the rods etc from riflecraft, think i'll go with these.

  9. #9
    Quote Originally Posted by Hunter686 View Post
    I use the pro shot stuff, its not coated but what i did was buy to some heat shrink from ebay. I can replace it s when dirty and also slide it up over the shaft of the jag and brush to protect the crown when scrubbing
    +1. Pro-shot stuff is very good.

  10. #10
    Just out of interest lads, how often are you cleaning your .204's?

Similar Threads

  1. *SOLD* .30 cal cleaning rod, brush, jag and mop.
    By Pine Marten in forum Other Shooting Equipment
    Replies: 2
    Last Post: 31-10-2014, 15:19
  2. Broken jag in cleaning rod
    By ferretmanabu in forum Cleaning, Gunsmithing and Equipment Care
    Replies: 12
    Last Post: 22-04-2014, 13:12
  3. cleaning rod to brush thread adaptor?
    By Mungo in forum Cleaning, Gunsmithing and Equipment Care
    Replies: 3
    Last Post: 07-06-2013, 21:08
  4. .20 cal cleaning rod
    By palo in forum Cleaning, Gunsmithing and Equipment Care
    Replies: 1
    Last Post: 28-03-2013, 08:33
  5. Adapter for PH rod to fit 8x32 brush
    By palmer_mike in forum Cleaning, Gunsmithing and Equipment Care
    Replies: 3
    Last Post: 21-10-2012, 18:15

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •