I have a S&B rail scope mounted to a Tikka with apel two piece mounts.
The bases are secured by a slotted knurled screw with a centre 3mm Allen screw.
Are these two separate screws? If so is the centre Allen a "locking screw"?
How tight should they be torqued to?
I have read they can be over tightened but can find no spec on correct torque.
All advice gratefully received.
The bases are secured by a slotted knurled screw with a centre 3mm Allen screw.
Are these two separate screws? If so is the centre Allen a "locking screw"?
How tight should they be torqued to?
I have read they can be over tightened but can find no spec on correct torque.
All advice gratefully received.