Results 1 to 5 of 5

Thread: Redding Trimming lathe cutter

  1. #1

    Redding Trimming lathe cutter

    Hello all,

    I have just bought a second hand Redding Trimming lathe cutter and was wondering if anyone knew how to set it up as there are no measurements on the actual cutter itself. I am reloading .243.

    Any advice greatly appreciated.



  2. #2
    and also, is it necessary to trim once fired cases??? does it greatly affect accuracy?



  3. #3
    set it up with the bit at the handle wound back and adjust the mandrel to touch the case when it is in the clamp then adjust the bezzle by the handle then cut and measure and keep doing this until you get the length you want then lock up.


  4. #4

  5. #5
    well once fired brass dont strech much good to keep them all the same length for consistanty

Similar Threads

  1. redding bushing size
    By bob257 in forum Ammunition, Reloading & Ballistics
    Replies: 7
    Last Post: 31-12-2010, 12:49
  2. redding competition rifle dies
    By tolley in forum Ammunition, Reloading & Ballistics
    Replies: 14
    Last Post: 27-11-2010, 13:55
  3. RCBS Trim Pro 3-way cutter
    By Moe 243 in forum Ammunition, Reloading & Ballistics
    Replies: 1
    Last Post: 28-06-2010, 21:38
  4. Redding Dies for sale
    By N.F.W.M in forum Reloading
    Replies: 3
    Last Post: 02-08-2009, 19:47
  5. trimming my bush (muffler)!
    By Offroad Gary in forum Deer Stalking General
    Replies: 4
    Last Post: 10-07-2008, 12:35

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts