Results 1 to 4 of 4

Thread: new moderator needing work

  1. #1

    new moderator needing work

    Hi all,

    just bought myself a new moddie for my already threaded .243 winchester coyote light, it is a reflex atec maxim and I need to get the rear bushing bored out to fit the barrel profile.
    If I had access to a lathe I could do it myself but failing that and avoiding the opportunity for me to mess it up, does anyone have a gunsmith in my part of the world to recomend for this job, I am based near Newmarket Suffolk/Cambs border.


  2. #2
    If its just a plastic bush do it yourself


    That's all I have done

    Section 161 of the Highways Act 1980 (England & Wales) makes it an offence to discharge a firearm within 50 ft of the centre of a highway with vehicular rights without lawful authority or excuse, if as a result a user of the highway is injured, interrupted or endangered.

  3. #3
    nice one apache, worth a try

  4. #4
    +1 - I have exactly the same mod as you and used a cone bit in my pillar drill for the bush, fits very nicely.

Similar Threads

  1. T8 moderator, annoying "tinkle" / Moderator care?
    By martinrs in forum Cleaning, Gunsmithing and Equipment Care
    Replies: 32
    Last Post: 14-02-2016, 21:39
  2. T 8 Moderator barrel screw fitting to rear of moderator
    By philip in forum Equipment & Accessories
    Replies: 7
    Last Post: 07-02-2013, 19:59
  3. For Sale job loss and needing to get my truck fixed.
    By bobjs in forum Firearms
    Replies: 0
    Last Post: 15-07-2011, 21:16
  4. Do you think it might work
    By Mannlicher_Stu in forum Equipment & Accessories
    Replies: 26
    Last Post: 18-02-2011, 10:28
  5. Here is one to work out...
    By nielaj in forum Deer Stalking General
    Replies: 18
    Last Post: 02-07-2010, 14:06

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts