Results 1 to 6 of 6

Thread: Shorter barrel in 6.5 x 55?

  1. #1

    Shorter barrel in 6.5 x 55?

    I've found a second hand blaser barrel in 6.5 x 55, however it is the shorter version 52cm/ 20.5 inches as opposed to the standard 57cm.

    my question is how does this affect performance in terms of recoil/ velocity e.t.c? Will it be fine and nothing to worry about or should I stick with a standard length one?


  2. #2
    My 6.5x55 has a 22" (about 56 cm) barrel, and when using a moderator I wouldn't mind it being a little shorter.

    Theoretically a shorter barrel will have lower muzzle velocity than a longer one, but I don't think you (nor the deer) will notice the five cm difference.

    Lower velocity would in theory give lower recoil force, but as per above, I don't think you will notice it. I don't think the shorter barrel will make the gun jump more around. I have a Remington 700 LRT in .308 with at 20" barrel that I use without a mod and it's a fine little gun to shoot.

    Personally I wouldn't hesitate to buy the gun with the 52 cm barrel. And, if using a moderator I'd see the shorter barrel as a benefit.

    Good luck,

    Last edited by Saugmann; 16-07-2013 at 09:43.

  3. #3
    My Sako 75 and already been cut from the standard 22 7/8" to 20 3/4" before I bought it, and with a Hardy Gen IV mod on the end, is pushing reloaded Hornady 140gr SSTs out at 2,660fps MV (46.7 grains N160)

    The cut removed 2 1/8" and the Hardy adds on 3 1/8", so technically, I'm adding 1" to the original barrel length (are you still with me..??)

    I can group 5 rounds at 1/4", and nothing has run further than it's own shadow so far (caveat: Roe only so far), so I'm more than happy with it!

    All this is purely my own rifle though, so a Blaser might fare differently, I don't know... Personally, I'd ask to see it shoot first - and if poss, shot it yourself - before spending any hard earned

    Sako 75 6.5x55mm-Z6i 3-18x50. MauserM12 .308-SIII 6-24x50. Beretta 690 III Field 12b.
    "You have enemies? Good. That means you’ve stood up for something, sometime in your life."
    Sir Winston Leonard Spencer Churchill (1874-1965)

  4. #4
    I have a Mauser in the same cal with the shortest barrel they do which I assume is exactly the same as the Blaser. It's great, you will have no issues.

  5. #5
    Thanks guys,

    i just wanted to check before rushing in. It is a 52cm barrel as standard from the factory. I guess they wouldn't make a short version if there were problems in performance. I'm sure it will be fine.

  6. #6
    Boarboy, just a bit more info for you. My Sako barrel is 23" and my CF2 Stutzen 19" (both in 6.5x55). The muzzle velocity is around 90FPS lower from the shorter barrel, but still well above the minimum velocity for deer using 120 grain Sierras and N160

Similar Threads

  1. Wanted 6.5 x 55 barrel r93
    By Boarboy in forum Firearms
    Replies: 2
    Last Post: 13-06-2013, 13:09
  2. Shorter barrels
    By big ears in forum Ammunition, Reloading & Ballistics
    Replies: 20
    Last Post: 06-03-2013, 22:22
  3. Wanted Sauer 202 6.5 x 55 fluted barrel
    By gaza916 in forum Firearms
    Replies: 9
    Last Post: 21-08-2012, 10:14
  4. What Caliber addition to 6.5*55 - R93 Barrel?
    By reddeer1 in forum Rifles & Calibres
    Replies: 5
    Last Post: 19-11-2011, 13:06
  5. 6.5 x 55 Barrel Length?
    By Ben82 in forum Rifles & Calibres
    Replies: 7
    Last Post: 12-10-2011, 09:41

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts