Page 1 of 3 123 LastLast
Results 1 to 10 of 23

Thread: Food safe metal finish

  1. #1

    Food safe metal finish

    I have some components for a mincer where the original finish has worn off.

    is there a way that I can get these metal components re-finished for not too much money. Must be totally food safe!

  2. #2
    Are the parts aluminium? What type of finish do they currently have? Maybe best to try getting them powder coated

  3. #3
    Mike, depending what part your better off buying replacement. What part?

  4. #4
    Quote Originally Posted by deer man View Post
    Mike, depending what part your better off buying replacement. What part?
    Agreed, but I can't get a replacement for the feed screw that pushes the meat thru the cutter/plate.

  5. #5
    You should be able to get a replacement worm for most machines. Try harder!

  6. #6
    Quote Originally Posted by deer man View Post
    You should be able to get a replacement worm for most machines. Try harder!
    Ok will do.

  7. #7

  8. #8
    Can't you get it shot blasted and bright zinc plated? or is that not food safe? I know it's relatively cheap.

  9. #9
    Quote Originally Posted by palmer_mike View Post
    I have some components for a mincer where the original finish has worn off.

    is there a way that I can get these metal components re-finished for not too much money. Must be totally food safe!
    What is the base metal and what is the "finish" that has worn off it?

    i.e. Do you mean a paint/lacquer or a metal plating? I am surprised there is anything like that which comes off on a food processing tool component, presumably it has gone into your mince.

    Maybe some photographs would explain your problem better?….

    Alan

  10. #10
    Ok I'll give a little more info and hopefully answer a few of your questions...

    the unit Is a buffalo CB943.
    the finish was stripped off in the dish washer (the instructions dos not say not to clean it in th dishwasher, oops).
    the damaged parts are all of the parts which come into contact with the meat.
    i can find spares for all parts except the worm.

    after the damaged occurred to my mincer the company who sold it replaces the entire unit, therefore I now have a spare unit that if I can get something done to fix the problem cheaply might be used. Otherwise I'll just keep the motor part as a spare

Similar Threads

  1. Wanted Ammo Safe and/or Rifle Safe
    By Bladerunner in forum Other Shooting Equipment
    Replies: 0
    Last Post: 23-10-2014, 22:12
  2. metal "bottom metal" for a Tikka 685/695
    By bewsher500 in forum Rifles & Calibres
    Replies: 3
    Last Post: 18-05-2014, 22:01
  3. food safe knife
    By dirtdigger in forum Equipment & Accessories
    Replies: 0
    Last Post: 08-05-2013, 21:11
  4. For Sale Gun Safe and Ammo Safe
    By insight in forum Deer Stalking Equipment
    Replies: 6
    Last Post: 11-05-2011, 20:51
  5. Food Safe Insecticide???
    By Pete E in forum Deer Stalking General
    Replies: 2
    Last Post: 28-01-2009, 12:13

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •