Has anyone had a conversion done on there Stainless X bolt trigger unit for the new feather light one?
I have been told the original trigger isn't easy to work on.
Loverly rifle but excessive weight on the trigger for my liking.
If the X bolt trigger is the same as the A bolt trigger then they are not hard to work on to achieve a decent trigger pull. I have tried the new featherlight trigger and it was pretty good out of the box. The Browning reps did say that the featherlight was designed not to be user adjustable.
X-bolt trigger is not the same as an A-bolt.
That said I found it straight forward to work on, remove and strip down, cut spring down and put it all back together.
Cutting spring about ½ a coil at a time I had to do it a couple of times, but ended up with a very nice trigger that broke at 1 ¾ lb.
The original trigger is dead easy to work on, it just has a red protective seal that you remove and you can then make the adjustment, i did on my 30-06 and i am more than happy with the trigger now.
Cheers
Richard
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.