Blaser scope ring fitting advice

[Glendine]

Hi Guys,

The Blaser scope rings are nearly ¾ cover the scope body and to get these rings over the scope without scratching the body of the scope has anyone got a method the used to spread the rings

For instillation - Please see attached picture of blaser rings
Any help would be greatly appreciated.

Regards,
Glendine.

 

[Lateral]

use a couple of allen keys, just inserted into the holes from the top. Press them together and the ring will open up.

Try it a couple of times first, to make sure the key doesn't go too far through, and scratch the scope

 

[Andrewslater]

Use a five, ten or 20 note and wrap round the tube, use the force required to pop the ring onto the tube, remove the note and perfect.

 

[Andrewslater]

£50 may be more appropriate as its a blaser

 

[artschool]

£50 may be more appropriate as its a blaser

as long as you set it on fire after to light your cigar.

 

[Glendine]

use a couple of allen keys, just inserted into the holes from the top. Press them together and the ring will open up.

Try it a couple of times first, to make sure the key doesn't go too far through, and scratch the scope

Many thanks for your reply, I am surprised there is no YouTube video on this.

Glendine.

 

[Glendine]

Use a five, ten or 20 note and wrap round the tube, use the force required to pop the ring onto the tube, remove the note and perfect.

Many thanks for your reply.

Glendine.

 

[Tam the Gun]

Try this

 

[NullMac]

Just push straight. They will not scratch. Counter intuitive I know.

 

[SussexSteve]

Be really careful doing them up very easy to cross thread in my opinion. I’d always buy tier one over blaser rings

 

[Glendine]

Try this

The only alternation id make to this video as I found the lamination sheeting cut worked really well as it tough and has a very smooth finish.

Regards,
Glendine.

 

[Pagans]

Two Allen keys in each opposing screw holes use like chop sticks and spread ,line up on lower rings place over scope and release slowly

 

[Stalker-of-the-deer]

Piece of paper over the tube and push straight down.

One they are on you can slide them up and down no problem

 

[Bavarianbrit]

Scavenge an old 1-2 thou feeler gauge blade then wrap it over the top of the scope tube & slide the mount on down over that which will keep the sharp edges off the scopes finish.