6x45 Quickload help please

[takbok]

In case no one sees this on my other thread. Is anyone with Quickload able to assist with finding which are the best powders for this bullet as I don't have manufacturers load data for these bullets?

I loaded up some 62gr GS Custom (243062HV084) last night and shot them over the chronograph. 2.34" OAL, CCI 450, Xterminator. All loads compressed.

28gr - 3120fps
28.5gr - 3180
29gr - no reading on chrony
29.5gr - 3244
30.0gr - 3223
30.5gr - 3271 (case overflowing)

Case capacity is 30.7gr water. Barrel length 20.5".

Thanks in advance,

Rory

 

[Jon Smith]

gs custom data available on gs custom web page

 

[takbok]

gs custom data available on gs custom web page

Unfortunately not for 6x45.

Unfortunately their data didn't work well for my .270 either so chose a powder based on recommendations from their NZ supplier which worked very well.

 

[NoIDeer]

You can find your bullet data in this file.

http://www.gsgroup.co.za/gscustom.zip

Instructions here

Bored at work!

 

[takbok]

You can find your bullet data in this file.

http://www.gsgroup.co.za/gscustom.zip

Instructions here

Bored at work!

Cheers but I don't have quickload so need somebody that does to run it for me.

 

[Jon Smith]

I meant the gs custom bullet data. Not load data.

 

[takbok]

I've just picked up a tub of Reloder 7 (Recommended for 6mm TCU loads by GSC) - will load some up and chronograph tomorrow.

The shop also had H322 but I felt that this was too close in burn rate to Xterminator.