Results 1 to 2 of 2

Thread: B Square Rail on Bergara B14

  1. #1

    B Square Rail on Bergara B14

    Hello all. I have just got a Bergara B14 .243 and the action is identical to a Remington 700 short action. I recently got a B Square weaver rail for it, and only three of the holes line up-the fourth is just slightly out of place.

    Will this be hugely detrimental? Should I get another rail?

    Thanks

  2. #2
    If the front two screws line up, it will be no problem with a .243 recoil, because most of the shearing and torsion force will be on the front of the rail.

    I had this same problem with a .30-06 where someone used Loctite on a screw, broke it off, and buggered the threads extracting it. I put on a rail and used it a good while, before I got around to drilling out the rail and receiver to replace the #6 screws with #8s.

Similar Threads

  1. 65 deer per square mile : too many ?
    By Spix in forum Deer Stalking General
    Replies: 5
    Last Post: 15-12-2013, 16:24
  2. Bi-Pod For A Square Stock
    By Jim xyz in forum Rifles & Calibres
    Replies: 2
    Last Post: 11-02-2013, 13:24
  3. Wanted B square level to fit pica tiny rail
    By swarovski in forum Firearms
    Replies: 0
    Last Post: 24-08-2012, 20:11
  4. Replies: 1
    Last Post: 24-03-2012, 09:24
  5. 6.5-06 A Square
    By PKL in forum Ammunition, Reloading & Ballistics
    Replies: 8
    Last Post: 15-09-2011, 23:20

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •