22 rimfire

[tony rentokil]

I have just bought a voere benteler and it ejects,but does not feed the next round.
I would be most grateful for any advise or pointers to a replacement mag,thank you Tony.

 

[Yorric]

It sounds like your magazine is bent. Assuming it's a pressed steel one. Check it hasn't been crushed & the shoe that the rounds sit on slides up freely after being pushed down against the spring. Next look at the top lips of the mag where the top round is restrained. These may have been bent down holding the round too low in the mag for the bolt to pick up.
Note small amounts of deformation to the mag will often stop rounds feeding. So tweak it a tiny bit at a time.
HTH

Ian