Blaser and Innomount Rings Question

[Rural Management Services]

Does anyone know if the Blaser and the Innomount 30mm rings for the bases are the same?

They look like they might me but it’s hard to be certain.

Blaser Single Ring, 30 mm

Blaser Single Ring, 30 mm

www.optics-trade.eu

INNOmount Single Ring, 30 mm

INNOmount Single Ring, 30 mm

www.optics-trade.eu

 

[WildBoarHunter]

They are not the same.

 

[AnthonyR]

I disagree, I have both picatinny and Blaser mounts here and have swapped over rings/bases between the two.

 

[Rural Management Services]

I disagree, I have both picatinny and Blaser mounts here and have swapped over rings/bases between the two.

So for clarity then you Blaser rings fit your Innomount base?

 

[Grannysmith]

R8 or r93?

 

[Rural Management Services]

R8 or r93?

It would be R8 I am interested in

 

[Grannysmith]

They dont fit my 93

 

[AnthonyR]

I only have an R8, the same rings will fit on a picatinny base and an R8 base.

You can also just buy the lower ring section on the Innomount website if you just want to change the height.

 

[AnthonyR]

Sorry but I am talking about all Innomount stuff, the Blaser rings won't fit on an Innmount base.

 

[JamesDeere]

I predominantly use Innomount setups on my Blasers, I find eye relief is less of an issue with them. Anyway……
I borrowed a friends Blaser mount to tide me over. Although it’s a bit hazy what I recall is,
the Blaser rings won’t fit in the Innomount slots, they’re ever, ever so slightly wider than the Innomount rings. I think the Innomount rings did fit on the Blaser base but weren’t snug in the slot, too much wiggle room.
Also the countersunk base screws are not the same dimensions or thread. I can’t recall which screw is the larger but the Innomount screw won’t fit the Blaser rings and vice versa.