KM Standard Neck turning kit with 6.5mm mandrel (you can buy whichever mandrel you like to suit your calibre from Spud etc. the expander mandrel and pilot are all you need to swap between calibres)
Kit includes:
Neck Turner body with cutter
Power Adapter (for use with handle or drill)
Power Adapter Handle
Expander Die Body
Expander Mandrel for 6.5mm
Carbide Doughnut Cutting Pilot for 6.5mm (upgrade on std.)
KM regular cutter (unused)
Additional:
KM Ergo Holder (makes holding the cutter much more comfortable)
KM Pilot Jack (unused)
KM 23º cutter (for getting closer to the case shoulder without leaving a step)
The only thing extra you need is a Lee (or similar) Ergo Prime Primer Shell Holder, about £5 as I just used the one from my set - No.2 for anything 308 derived (243, 260, 6.5cm, 308 etc.)
All instructions clean and unmarked. All kit virtually as new - I used it on my 100 Peterson Match cases, that's it. Total new cost approx: £260
Billy Bargain at £195 posted RM48 tracked.
Kit includes:
Neck Turner body with cutter
Power Adapter (for use with handle or drill)
Power Adapter Handle
Expander Die Body
Expander Mandrel for 6.5mm
Carbide Doughnut Cutting Pilot for 6.5mm (upgrade on std.)
KM regular cutter (unused)
Additional:
KM Ergo Holder (makes holding the cutter much more comfortable)
KM Pilot Jack (unused)
KM 23º cutter (for getting closer to the case shoulder without leaving a step)
The only thing extra you need is a Lee (or similar) Ergo Prime Primer Shell Holder, about £5 as I just used the one from my set - No.2 for anything 308 derived (243, 260, 6.5cm, 308 etc.)
All instructions clean and unmarked. All kit virtually as new - I used it on my 100 Peterson Match cases, that's it. Total new cost approx: £260
Billy Bargain at £195 posted RM48 tracked.
Last edited:
