Sold: PSE E-Lite Tikka t3/t3x SA fit

Tikkat1x

Well-Known Member
This stock is 100% as new, not a single solitary mark on it anywhere,
iv only owned it just over a week, and as beautiful as it is, and something iv always wanted, iv quickly found its not for me.
i find it hard to reach the trigger without sliding my hand right up the stock, dont have as much stretch in my trigger finger due to a dog attack many years ago.
so sadly it has to go. comes with all it came with from the factory, x2 butt spacers, x2 flush cups, front sling/bipod stud, 2 threaded holes for a small pic rail, iv also bought a new Quake The Claw 2.0 QD Flush Fit Socket Swivels Rifle sling, SURE GRIP. in black thats never been used, comes with bottom plastic and takes factory tikka fit mags, posted to your door RMSD,
£1,000IMG_5430.jpgIMG_5425.jpgIMG_5428.jpg
 
Interestingly I had to modify the hand grip to make it vertical to allow proper trigger control for me too on mine…. I used epoxy putty and a rubber floor paint. I think they do a version with a vertical hand grip which might suit u better IMG_6225.webp
 
Here’s the results I used epoxy putty and a sander (actually a die grinder with small flappy pads on) and finished by hand. Then used protectakote black rubberised paint it’s been dragged all over scotland since and had a couple of paint repairs but nothing unusual just stone dike eating the corners IMG_7087.webpIMG_7086.webpIMG_7084.webpIMG_7085.webp
 
Back
Top