Sold: PSE E-Tac Tikka t3x SA

[Tikkat1x]

I have a PSE E-tac Mil spec that im selling, but there is a "but"
and that but is, its £1100 posted,
the reason being, its as new, not a single mark, scratch, scuff on it,
its just had a new PSE pic rail fitted, properly screw cut, and a new PSE butt pad on it as the original one was a bit soft,
its also just had some grovtec flush cups fitted, i got a bit carried away a few weeks ago and bought 2 of them, one for my 223 and one for the 243,
im supposed to be getting rid of the 243 as i now no longer have use for it, it also comes with a newly fitted atlasworx bottom metal, and a AICS 5 shot polly mag,
still a few hundred cheaper than a new one and a 8-12 month wait, no part ex's or offers, if its not worth my asking price i will happily keep it, as i know i will regret selling it some day.

 

[Dave_45]

Swap for an E lite in the same condition?

 

[Tikkat1x]

Had to sell my last E-lite as due to an old dog bite on my hand, i struggled to reach the trigger,

 

[Tikkat1x]

Gone, but never forgotten

 

[Fox246]

Slotted in perfectly had to file the top of the mag down for it to click in but all good now cheers mate

 

[Tikkat1x]

View attachment 471311Slotted in perfectly had to file the top of the mag down for it to click in but all good now cheers mate

Lovley mate, i had to mess with my mag too, took off far more than id of liked, but fit eventually,

 

[C h r i s]

Lovley mate, i had to mess with my mag too, took off far more than id of liked, but fit eventually,

That's kind of put me off buying a PSE stock. Never had to make any adjustment when using a MDT stocks with AICS mags.

 

[Tikkat1x]

That's kind of put me off buying a PSE stock. Never had to make any adjustment when using a MDT stocks with AICS mags.

i had to sand my mag down to get it in the MDT XRS, went straight in the PSE, had MDT AICS mag in the 243, and begara AICS mag in the 223, both mags needed serious fettling to go in,

 

[andyk]

That's kind of put me off buying a PSE stock. Never had to make any adjustment when using a MDT stocks with AICS mags.

If it’s an Atlaswerx bottom metal, In think they say they deliberately make the mage release on the long side so it can be set to the right length for the stock being used.

 

[Fox246]

It didn’t take much to file the top of the mag. Could probably of tapped the top edges to fold them in a little bit. That’s with a atlasworks bottom metal and accurate mag.