Slide Hinges for truck bed pull out tray

[johnnytheboy]

I want to make my own pull out tray, any good suppliers for hinges / slides for full length bed pull out tray?

Thanks in advance

 

[Klenchblaize]

Just make sure they have an over-stop feature.

K

 

[starr shot]

A Company called Hillview engineering made one for me with very strong rails on it may be worth giving them a ring I know they are based in the west country but they might be able to tell you where they get theirs from 01934 740498

I want to make my own pull out tray, any good suppliers for hinges / slides for full length bed pull out tray?

Thanks in advance

v

 

[FISH BOY]

I want to make my own pull out tray, any good suppliers for hinges / slides for full length bed pull out tray?

Thanks in advance

I made my own tray/slide a few years ago.

Still going strong.

Thread 'How to make a truck tub bed slide.'

Jul 5, 2020

Became sick and tired of climbing in the back of the truck to get stuff, I needed a solution.

Looked at making draw unit, but thought they come up too high, take up too much space and to be honest didn’t really know what I would actually want to leave in it. Then started looking at custom made commercial roller slides which looked ace, but required drilling of the tub and winced at the cost of them.

So I set about making my own basic slide. Its turned out quite practical for £100 worth of bits and as there are no doubt a number of fellow members with pick up style trucks facing the same...

• FISH BOY
• Replies: 27
• Forum: Off Topic

• 

 

[B&W FOX]

This set up was made by the previous owner of the truck. They used 22mm box section for the runners and bolts with a stainless shim added top and bottom of the runners held in place with locking nuts. It's over engineered but has never failed or jammed.