For Sale: Optilock Tikka Mounts and Rings (30 mm diameter, Medium height) - £70

[chriswjx]

Have these for sale.

Came off a scope I bought. I have been led to believe that these have never been out of the cabinet (or possibly even on a rifle), as the original owner never used the scope (S&B 8x56) - and certainly when getting the scope out of these, they were not tightened at all, and they appear visually immaculate.

Not sure what height rings they are, so have a picture of them against a ruler. But I am confident in them being for 30 mm tubes, as that was what the scope was

No idea on value (as I've only just started shooting), but was suggested by a local RFD to ask for £70 inc postage £80+postage for them (and seems like a reasonable starting point when I check some past listings on here?)

this is of the front (I think) mount, with the little nub supposed to indicate that these are for the tikka rails?

 

[chriswjx]

Price dropped to £70 including postage to a UK address

 

[Donkey Basher]

This chart gives you the information to determine what height the rings are - dimension H is what you're looking at. If it's 32.5mm they're low, if 36.5mm they're medium. From your pic it looks like they may be low but then difficult to tell as bottom of the steel rule might not be at the bottom of the base & angle could mean the reading up the rule is at an angle so could be medium. If dovetail on the bases is parallel & both bases have the same width dovetail then 100% Tikka.

https://www.dauntseyguns.co.uk/downloads/OptilockTechnicalSpecifications.pdf

 

[chriswjx]

This chart gives you the information to determine what height the rings are - dimension H is what you're looking at. If it's 32.5mm they're low, if 36.5mm they're medium. From your pic it looks like they may be low but then difficult to tell as bottom of the steel rule might not be at the bottom of the base & angle could mean the reading up the rule is at an angle so could be medium. If dovetail on the bases is parallel & both bases have the same width dovetail then 100% Tikka.

https://www.dauntseyguns.co.uk/downloads/OptilockTechnicalSpecifications.pdf

Thanks!

Have measured according to the spec sheet and would say these are mediums.

Can also confirm that the bases are both parallel and have the same width (at least measuring with my steel rule as only god knows where my calipers are at)