Yes.
For Sale: 384x288 Thermal Scopes for £399
- Thread starter Immersive Optics
- Start date
kenbro
Well-Known Member
I think that would be expecting a bit too much of something at that price point.
KB.
HonestJohn
Well-Known Member
Which in that case probably best left to rabbits or rats no?
We will be uploading a few videos tomorrow, showing rabbits filmed from 30 to 120 yards.
I just ordered one, hoping the unit matches the hype, will go in the stores as a back up if tests confirm comments on here.
bicykillgaz
Well-Known Member
My two arrived today, I've just collected them on my way to work.
I've only been able to have a look at it in and around the car park but could clearly see/ID/shoot pigeons at over 50yrds on the roof of the mill. The only other thermal I've owned is the base level 30mm gen 1 Pulsar Axion and I would say it's a similar quality in the environment I was in. I'm guessing at longer range and when zoomed in is when you may/may not notice a difference.
They look an absolute bargain for the money and perfect for my .22lr and as a spotter. I can't wait till I finish nights and can get it zeroed Monday.
I've only been able to have a look at it in and around the car park but could clearly see/ID/shoot pigeons at over 50yrds on the roof of the mill. The only other thermal I've owned is the base level 30mm gen 1 Pulsar Axion and I would say it's a similar quality in the environment I was in. I'm guessing at longer range and when zoomed in is when you may/may not notice a difference.
They look an absolute bargain for the money and perfect for my .22lr and as a spotter. I can't wait till I finish nights and can get it zeroed Monday.
A small number of Nordforce Thermal Riflescopes have a little problem where the device does not save the zeroing profile and asks to select the language and battery voltage every time it is powered on.
This issue can usually be resolved through the scope menu by following the steps below.
If you are having any trouble, please contact operations@immersive-optics.com and we will help you.
This issue can usually be resolved through the scope menu by following the steps below.
Troubleshooting Procedure
- Remove the battery from the scope.
- Connect the supplied USB cable and power the scope from USB only.
- Select the language and battery voltage settings to reach the main screen.
- Wait for approximately 10 seconds before continuing. This step is important.
- Press and hold the Menu button to enter the main menu, and change your brightness a little. Changing brightness initiates scope firmware writing to memory.
- Press the Down button 12 times and open the Restore menu.
- When the scope asks “Initialize?”, select OK.
- The scope may display “Initialization failed”with a red icon.
- If this happens, do not switch the scope off.
- Wait for the scope to reboot automatically.
- If initialization fails, repeat steps 3–8 two or three times until the scope displays “Initialization succeeded” with a green icon.
- Allow the scope to reboot automatically once more.
- Select your language and battery voltage settings again.
If you are having any trouble, please contact operations@immersive-optics.com and we will help you.
Last edited:
Just received the unit, I need a download link for the current issue manual
Just received the unit, I need a download link for the current issue manual
Did I see that all the units sent out recently have been firmware upgraded?, Ste.
Had it running, pretty sharp image, pretty robust feel to it, only drawback for me is the usb port cover can be mistaken with sausage fingers for the usb plug (Note to self, make sure you ARE pulling the usb & not the cover.)For handling USB connections, sausage fingers are not as bad as an extreme case of nail extensions
Snowball71
Well-Known Member
Hi.. has the latest firmware update solved the zeroing profile problem or do I need to check that when I receive the unit...thanks
Solved
Similar threads
