Bullet puller

Morning S - I know you boys up there like your pennies - a wire stripper set of pliers does pretty much all calibers. Just put the bullet in the case holder on your press, remove the die, raise the bullet through the die hole, grasp bullet with pliers and pull lever…
🦊🦊
 
following this because i used a kinetic hammer for years but i'm sure there must be a better way
 
I have both a kinetic hammer and a Hornady collet bullet puller. The bullet puller is neater and cleaner and doesn’t take repeated whacking of the hammer. It also is just more ‘clinical and efficient’
But there are times where I reload something a midge too short and then I reach for the kinetic hammer - a few blows to lengthen COAL again, then back through the die for a second attempt.
 
I have a full set of collet jobbies and find them shiiite.
I use the kinetic from RCBS which is fine but sadly the aluminium case grippers wear out too fast, now I just put the reloading press shell holder into the kinetic which works and will not wear out.
 
I like the kinetic hammers. Not because they are enjoyable to use but because they encourage you to never louse it up again.
 
If you use RCBS get collets larger than the bullets you want to pull. Otherwise it tries to grip the ogive with predictably shite results.
 
Back
Top