Help with him alpex 4k lrf

[chaz243]

Hi folks.
I was trying to zero my new scope yesterday and after bore sighting I was on paper.my first shot was into the dirt 25 cm below aim point. Did the correction but struggled to get to the "ok/cancel parameters" screen to set it at "ok"..?? .
Question is is my mount ok .. apel mounts on a sauer 202 that have held zero with a swaro 8 x 56 for years with no probs .Off to potters shortly so any help would be greatly appreciated . Cheers.

 

[tarponhead]

I have found the controls take a bit of getting used to. Play with it at home and you’ll get the hang of it - when your happy with where it’s set, you long push the menu button to prompt the save or cancel and then click the menu button to say yes, then long click to get out of that menu. Others may have a better method. Have a look on You Tube for demo’s.

 

[chaz243]

I have found the controls take a bit of getting used to. Play with it at home and you’ll get the hang of it - when your happy with where it’s set, you long push the menu button to prompt the save or cancel and then click the menu button to say yes, then long click to get out of that menu. Others may have a better method. Have a look on You Tube for demo’s.

Thanks.thats exactly what I was doing but to no avail. I ve heard the buttons can be a tad stiff..

 

[Dave_45]

Zeroing via the app is much easier


Fire your shot , walk to target , measure adjustment needed , remembering you are moving scope to impact point not impact point to scope.

Walk back and input adjustments via app.

Fire again and re adjust until you are happy

 

[chaz243]

Many thanks. I will try this ..much appreciated.
C ..