Hikmicro Alpex 4k
- Thread starter Happy stalker
- Start date
.270s202
Well-Known Member
I hadn't updated for ages due to it working fine and seeing issues with updates,
Saw the new update today, downloaded it, then once home went to apply it,
Apparently now i have the update that makes the reticule super thin, and the new update i saw earlier dosent seem to exist now!!
Not overly happy
Saw the new update today, downloaded it, then once home went to apply it,
Apparently now i have the update that makes the reticule super thin, and the new update i saw earlier dosent seem to exist now!!
Not overly happy
I hadn't updated for ages due to it working fine and seeing issues with updates,
Saw the new update today, downloaded it, then once home went to apply it,
Apparently now i have the update that makes the reticule super thin, and the new update i saw earlier dosent seem to exist now!!
Not overly happy
Hikmicro Alpex 4K Firmware Update - September 2025 — HIKMICRO ASSIST UK
The newest firmware update for the Alpex 4K - September 2025 Firmware Download; https://www.dropbox.com/scl/fi/0ptbtj5u6rcr2fdql76f2/digicap.dav?rlkey=xrbqjfa3ix4jye69rq4kxp5ou&st=avueo3nv&dl=0 ‘How-to’ video - please refer to the second half of the video that goes thro
www.hikmicroassist.co.uk
My zero co-ordinates were the same but I lost my ballistic calculation information, but that might have been from the reset I did after the update . Cross hairs are a lot clearer in my opinion & picture quality looks better
.270s202
Well-Known Member
Thanks, that's sorted it!
Go to the arrow top right corner and down load.Hikmicro Alpex 4K Firmware Update - September 2025 — HIKMICRO ASSIST UK
The newest firmware update for the Alpex 4K - September 2025 Firmware Download; https://www.dropbox.com/scl/fi/0ptbtj5u6rcr2fdql76f2/digicap.dav?rlkey=xrbqjfa3ix4jye69rq4kxp5ou&st=avueo3nv&dl=0 ‘How-to’ video - please refer to the second half of the video that goes thro
One on top of two
Well-Known Member
Both of mine updated via sight app , reticules are back to normal and thicker .
Daytime image in bright sunlight is also much better .
Daytime image in bright sunlight is also much better .
Tom Highway
Well-Known Member
It is suggested that immediately after you do a firmware update you use the “restore”function, this will reset some things on the scope, most notably it will wipe the ballistic data i.e. velocity BC etc. but it should keep X and Y settings. They suggest you do this to “flush out” any old bits of firmware that might be still in the scope, which might cause issues conflicting with the new firmware. You can off course not do it, and probably be OK and the scope will retain all its settings after an upgrade, but some people do have issues after upgrades, loosing all there data on the scope. If you give this ago make sure it’s restore you select and not reset ! As then you will definitely loose all your data !!
Just loaded the new firmware v 5.5.140 and no problems... all looks good. I did notice that a code is now displayed in the scope on completion of the S/W load. I'm presuming that this handshake negates the 'restore' requirement? All data seems to be stores... we will see when I shoot it...
Similar threads
