ID help needed: Wooden stock identification
- Thread starter drago
- Start date
SAKO
drago
Member
Thank you for the replies!
I’ve checked the action screw spacing again, and it’s approximately 195mm (roughly 7.67 inches). I realize this is too long for a Sako Forester (L579/Medium Action), which is usually around 175mm. Given this length and the right-hand safety, could this be for a Sako 75 Action IV (Long) or Action V (Magnum)?
Also, the inletting has been professionally glass-bedded and has pillars installed. The "screws" I noticed inside appear to be part of the bedding job. Any confirmation on which Sako model this matches would be great!
I’ve checked the action screw spacing again, and it’s approximately 195mm (roughly 7.67 inches). I realize this is too long for a Sako Forester (L579/Medium Action), which is usually around 175mm. Given this length and the right-hand safety, could this be for a Sako 75 Action IV (Long) or Action V (Magnum)?
Also, the inletting has been professionally glass-bedded and has pillars installed. The "screws" I noticed inside appear to be part of the bedding job. Any confirmation on which Sako model this matches would be great!
Magnums can have the cross bolt through the stock side.
Similar threads
