Post hole borers - they bite

Just transplanted a couple of hundred yards of daffodils with the aid of one.
I was advised to lean over it if operating it on my own. I wore the front out of my shirt!! Thumbs ached like hell for the next couple of days. It took off a couple of times but I knew enough to let go. I have a layer of stone and gravel just before the optimum depth for daffs. The other option was the family bulb planter which is pre war at the very least.
Commiserations
 
Last edited:
Just transplanted a couple of hundred yards of daffodils with the aid of one.
I was advised to lean over it if operating it on my own. I wore the front out of my shirt!! Thumbs ached like hell for the next couple of days. It took off a couple of times but I knew enough to let go. I have a layer of stone and gravel just before the optimum depth for daffs. The other option was the family bulb planter which is pre war at the very least.
Commiserations
I did 200 m of planting daffs I just used a 80 mm core bit on a cordless 18v drill . The core was 150 mm deep +the shank so any amount of depth
 
I don't think one of those things would even scratch the surface here.
Had to use a JCB and rock pecker to make holes for not only the strainers, but every single intermediate post, when putting up my deer fence.
 
Just looked more closely at the OP...

Top tip for anyone, it you're using an extension bar to get extra depth, put the auger in without the bar, then when you're at full auger depth stop, fit the bar, and start again. That way you're never trying to control it up by your face/chest.
 
Just looked more closely at the OP...

Top tip for anyone, it you're using an extension bar to get extra depth, put the auger in without the bar, then when you're at full auger depth stop, fit the bar, and start again. That way you're never trying to control it up by your face/chest.
Lesson learned the hard way, that's for sure 🤕
 
Back
Top