Zulus V1 and the .22lr

[nf-fuse]

I have a zulus v1 for my Brno mod 2, but it came with a 0moa rail and I cant make it work! What do others have the 20moa or 35moa rail?

I need to buy one, but would rather not buy two!!

T

You can adjust the elevation by putting shims under the scope. Where the 4 screws are that attached the scope to it's mount.

I currently have this in ya 17hmr and I'm not losing zero.

Assuming you're hitting low you would want to shim the rear of the scope mount.

You can cut shims from a drinks can with scissors.

If you need it doesn't fit the rail then no it only works on 9/11mm dovetails (and even then I would say the mount is very narrow).

 

[Tdes]

The impact is below the bottom of the scope image. I thought about shimming but may just get another base for it with moa built in. Just can’t work out if I need 20 or 35 for 22lr on a brno

 

[nf-fuse]

The impact is below the bottom of the scope image. I thought about shimming but may just get another base for it with moa built in. Just can’t work out if I need 20 or 35 for 22lr on a brno

Can you measure how low it's hitting with the reticle unzerod on the vertical plane?
If so you should be able to work out how much moa you need.

I don't think anyone can give you an answer because every gun and rail etc is slightly different.

The zero moa rail will probably be too low on a 22rf. I think they come with a 20moa rail now (picatinny).