Custom turret or label

[swagger700]

Hi has anyone had any done ? ,would be for nightforce scopes
Thanks Jon

 

[Austin]

If you have a printer you can buy paper thats sticky on one side and make your own on this site TurretLabels.
Might be worth a try to see if you like it before you invest in a custom turret

 

[Muir]

I like what the guy on THLR long range did. He simply put tape on the turret and marked 200, 300 400, etc. Quick, simple, no fuss.~Muir

 

[DVS1]

I've ordered from the USA site before and a great service however with atmospheric changes it's easier to use the THLR method, the fact its white isn't going to scare anything I'm sure

 

[Jelen]

I like what the guy on THLR long range did. He simply put tape on the turret and marked 200, 300 400, etc. Quick, simple, no fuss.~Muir

Yes. On my nightforce I used white electricians tape and marked the ranges with a Staedler fine permanent felt tip. Never rubbed off and visible at night using a red headlamp.

 

[Edinburgh Rifles]

White electrical tape
Fine sharpie

 

[swagger700]

Thanks for feedback , that's pretty much what we do at the moment just wondered if anyone has had a turret done
Thanks jon

 

[Muir]

There is always a certain degree of impracticality in having turrets made, or spending a lot of time making custom turret markings. If you find a new load (and if you're like me, you will the moment you get a custom turret) your work was for nothing. ~Muir

 

[swagger700]

Ye agree , I would hope I'm set calibre wise but you never know! !

 

[Sonicdmb73]

Far better to make a dope chart to stick in your flip up scope cap or on the stock.
Personally I have tried to use both scopes with calibre specific turrets and made my own with tape and marker pen. Non were very satisfactory.
I find that if I am far enough to dial I usually have time to use Strelok and range wind readings etc and get a better dope. Than a one fits all if you’re lucky one.

 

[Pete6.5]

I use a dash of white nail varnish but next time I will try some glow in the dark nail varnish ( never had it come off but when I what to change it a bit of pressure from the back of a knife and it pops off)

 

[parabellum]

Just stick a waterproof dope chart with a lightweight holder to your rifle. You can also change if you change load.

 

[Doric]

Hi has anyone had any done ? ,would be for nightforce scopes
Thanks Jon

Sticky labels and fine calligraphy pens. I have my FAC airgun, 22, 222, 243 6.5 Creed, all wrapped with DIY labels and they do the job perfectly.
Shoot your zero and shooting on paper mark off your drops in 5 yard increments for lower power air 10 yard increments for FAC air or 22lr, 25 yards for centrefire. My stalking rifle is set for a 200 yard point blank then 25 yard increments thereafter.