Digiscoping and adapters for Smart phones.

Heym SR20

Well-Known Member
Looking for advice please on good tough adapters so can use my iPhone to take pictures with my spotting scope. I have a Kowa 75mm objective lense with a 32x eyepiece.

i do have one for use with nikon DSLR but very mixed results as a struggle to get light metering correct.
 
You should go into business making these I’d be the first to order one 👍
atb
I must say, just using a very cheap (£10) camera the system works very well - Using it with a spotting scope with a 7" tablet for pistol shooting works well, don't need to change your position at all.

The problem with 3d printing is the plastic filament shrinks a little but not always consistently. This means it's far better to have the object on hand and use a bit of trial and error with the design and fitting. For example, you want to print a sliding bush for a 30 mm shaft, the design is very easy, you might design the hole to be 30.1mm and find with that particular batch of filament at the temperature is not big enough hole, I usually print several test pieces to get the size to fit just as I want.

This is on a bigger scope:


I use the same little cameras on my loading scales with a 3d printed bracket.
 
I've used some Phone Skope products for a few years and been very happy with them. I've used the ones that are specific to an optic, and the one that allows it to be adjusted and mounted to a variety of optics. The ones that are specific to an optic are easier to use, and offer a more consistent mount.


I'll be glad to share photos of mine and photos taken with them if you'd like me to do so.
 
Back
Top