Hanging roe skull without a shield

[Kimura84]

Hi all,

I want to hang this Roe skull on the wall without a shield. I don't suppose a bog standard skull hanger will do the trick. Does anyone have any recommendations on how this could be done?

Thank you

 

[lochty]

How about filling the skull cavity with epoxy, but embed a loop of wire in it and use a standard picture hanging fixture.

 

[Morkai]

Just a nail, or hang it like a picture by attaching some cable inside.

 

[Ade8mm]

Like Morkai suggests. Just hang it on a nail.
(Just a bit more carefully)

 

[VSS]

I concur. A nail and a bit of wire.

 

[scotch_egg]

Hung my malform on a screw for years

 

[Kimura84]

Thanks for the suggestions. Pardon my ignorance but where would the wires thread through so they are not visible from the front?

 

[VSS]

Thanks for the suggestions. Pardon my ignorance but where would the wires thread through so they are not visible from the front?

 

[roaring_stag]

How about filling the skull cavity with epoxy, but embed a loop of wire in it and use a standard picture hanging fixture.

Arts and crafts Dave….. sounds amazing!

 

[Kimura84]

Thank you!

 

[User00040]

Drill direct through skull into wall

 

[Sol]

Dremel the inside to create a notch where the screw holds on a bit better its cut anyway not like a few extra mills of bone will hurt it at all.

I hang my roe from the eye bone behind the socket its a nice view compared to what's usually done, I tie the lower jaw too, There just hooked on so by the bone so they can be lifted off and passed around for people to look at.
Or for myself to use for art refences.

 

[StephenToast]

Just hang it off a screw. No need for wire.