Plastic wall liner
- Thread starter Hawshill
- Start date
Gloss White Bathroom Panels Ceiling Cladding Shower Wall Kitchen PVC DBS | eBay UK
Tile Effect Panels. At DBS Bathrooms, we know the importance of providing quality products at the right prices. Our showroom and warehouse is now based in Two Gates, Tamworth. Here are more great reasons to choose DBS.
ebay.us
Hygiene panels. They come about 3mm thick. There wobbly as hell to put up but really tough once up. From eurocell or cladding monkey
@theroedeerguy
Well-Known Member
I used this stuff which was able to be put straight on to studwork and each panel interlocked with the other.
Straight to studwork is better but can be a bit echoy and reverberating if your studs are a bit uneven and you dont have decent insulation behind but works fine
Its pretty strong once well supported on the wall but won't put up with regular bashing and knocking it's only foam board so if you wheel things in and out and knock into it you'll want stainless plate on top
Its pretty strong once well supported on the wall but won't put up with regular bashing and knocking it's only foam board so if you wheel things in and out and knock into it you'll want stainless plate on top
Ruby Tuesday 2
Well-Known Member
Parlour board is good but needs a solid backing like ply or osb. Watch out for some of the hollow type shower boards as the first pricket that swings at it as you lift it up Eli puncture it with his antlers than you have to strip the whole wall down to replace a middle board.
Bavarianbrit
Well-Known Member
In Ontario in 1971 I was working at a small company that took 3ply 8x4 sheets with one side bad and we laid them out on steel tables 9x5 with the good side up then poured a measured amount of white epoxy mixture on the ply and spread it out, then a roll of fibreglass was rolled over the sheet, followed by a sheet of very thin but very strong Mylar over that which was taped down all the way around to give tension to the Mylar it was stuck to the steel table. We then used like window cleaners squeegees to work the epoxy up into the glass mat and swept all the air bubbles and excess epoxy out to the sides and left it to cure for an hour. What came out were very strong clear white 8x4 strong sheets which after trimming off the waste were for lining refrigerated truck bodies. They would take a lot of damage IMO if anyone wants to try making it. The Mylar was sold as drafting film by Ozalid.
You could look to fibre glass the inside, a bit like a milking parlour.
Watco or resincoat do some very decent solutions for that but it is a hell of a lot more prep and faff than sticking up hygiene board over what is there
I thought it might be. The hygiene board is floppy old stuff but if stuck to osb it's not too difficult to put up. I cut it with a circular saw with just about 5mm blade sticking out.
I did the same. Much quicker /neater than a jigsaw which is what I tried the first time
paul dillon
Well-Known Member
used hygienic white boards on mine easy to install bit floppy but works well got it on line with adessive and roller
Similar threads
