Ultrasonic cleaner recommendation

[MAH]

Hello all. I am planing to buy an ultrasonic cleaner.
Please let me know what you use / recommend.
Make, model....
Thanks
M.

 

[Alantoo]

£130-ish 5 years ago 10 litre stainless steel eBay with the analog time and temperature controls rather than digital.

Large size was bought to take Briggs and Stratton carburettors...I use honey jars with the cases and cleaner in to keep the main body of water clean.

Alan

 

[DingDongDen]

I have used an ultrasonic cleaner for a long time and swear by it. After washing I blow dry with a heat gun. Stand 'em up on a metal oven dish all done and ready to load in 20mins. Try....UK. Banggood...cheaper than ebay with good choice (same chinese makes but much cheaper).

 

[jb1]

This is simliar to what i have.
Amazon

 

[Cooter]

I bought a 2.0 ltr one off ebay many years ago (still about £75 for the 3.0l unit).
It gets used for many hours each month and it still works as it should.

I still have the JML one that it replaced, the JML one cost £100 about twelve years ago, but some of the resin broke off the vibration unit and it was always limited in use as it only has one central vibration unit, where the ebay unit has two.

 

[20-250]

Had an ebay one, lasted 20 minutes of use. Chinese seller, I think I got a refund of about a third of the cost.
Go for a wet tumbler bought in the UK would be my advice.

 

[JTO]

Mine is a Lyman. I think the quicker you deprime after shooting and get them in the cleaner, the fewer 8 minute cycles are needed.

 

[Jimbob39]

Amazon one, it works well with a couple of tea spoons of citric acid.

 

[paul o']

This is simliar to what i have.
Amazon

I got the same one i'v used it twice and a dehumidifier 5 tray no longer use them as i'v gone back to tumbling so sitting under the bench .

 

[Doric]

Braso and a battery drill . Warning ! use dark glasses or the shine may be detrimental to you eyesite.

 

[paul o']

Brasso ? hmmm not for me it contains an ammonia based cleaner it leaves a film that has to be then wiped off , should you get any inside and it will if enough is in there clump your powder ?? let alone up the pressure when /if it go's off , far better safe forms out there to use ,

 

[Klenchblaize]

So far I’ve been lucky case tumbling with an added glug of Braso post ultrasonic clean but I do allow the cases to first fill with media before introducing the stuff. I also leave the tumbler outdoors for at least 8-hours to do it’s stuff.

I use a Kerry ultrasonic cleaning bath.

K

 

[Alantoo]

I think most of the stainless tank ones on eBay or Amazon are made by GT Sonic in China and rebadged to Sealey or whoever...

Alan