Blaser mount for a Pulsar Thermion

[30-06]

Hi
Could someone help me in which height mounts would fit the Thermion xq38. Can I use a low mount or would it have to be a medium or high.

Thank you

 

[Coddy]

Not a Thermion but a Tier One picatinney on a Blaser mount.

Im not sure of scope height with Rings as both my scopes are Swarovski Rail, and this is 45mm centre to centre with 56mm objective lens.

 

[Freeforester]

Not a Thermion but a Tier One picatinney on a Blaser mount.

Im not sure of scope height with Rings as both my scopes are Swarovski Rail, and this is 45mm centre to centre with 56mm objective lens.

How high above the bore is the scope centre, out of interest? When I had one, it looked like this

 

[phillips321]

I use this with my ATN Thor4 scope and prefer it over the standard blaser mounts. MUCH better quality and clamping system:
Alan Rhone Store

 

[Coddy]

75mm.
Its ok out to 200m and dont go much past that on the foxes.

I will upgrade to a Thermion if they ever take one out with range finder.

 

[30-06]

I use this with my ATN Thor4 scope and prefer it over the standard blaser mounts. MUCH better quality and clamping system:
Alan Rhone Store

I take it the Thor 4 takes the standard QD mounts of blaser like the Thermion. Do you have the low mounts in them?

 

[phillips321]

The Thor4 doesn't fit in standard Blaser mounts.

 

[JamesDeere]

The belly of the turret housing is 6.3mm beneath the main tube according to Pulsar’s specs so you’re looking at the high??? rings or ones at least 7mm high for the thermion to sit on the mount.

 

[20ppc]

Hi
Could someone help me in which height mounts would fit the Thermion xq38. Can I use a low mount or would it have to be a medium or high.

Thank you

The Innomount on the Sauer 404 needs to be the High for the Thermion. The Blaser mount is very similar.

 

[TonyC]

Hi
Could someone help me in which height mounts would fit the Thermion xq38. Can I use a low mount or would it have to be a medium or high.

Thank you

On my Thermion XQ38 I have high rings which gives me about 1/4" clearance on the front of the scope. Hope this helps.

 

[shearstu]

I had to get ring raisers wen I got my thermion going from 56 mm scope to the thermion this worked great but couldn’t get the eye correct as couldn’t move back far enough
Ended up getting a innomount which is specially designed for the blaser/ thermion and is perfect height and eye relief is spot on
Got another dayscope back in the old blaser mount

 

[30-06]

The belly of the turret housing is 6.3mm beneath the main tube according to Pulsar’s specs so you’re looking at the high??? rings or ones at least 7mm high for the thermion to sit on the

High rings it is then. Thank you.

 

[30-06]

Thank you all. Shall go with the high rings.
Cheers

 

[swagger700]

I got the extra ring spacers but that was for digex. There's plenty of room between barrel,ring your blaser shop they should know