Hanging gantry/ frame ideas

[Rake Aboot]

Folks
Looking for ideas for a gantry , frame for hanging deer , one that folds away to stand against a fence when not in use

Anyone seen anything or made anything ?

 

[Cottis]

For inside a chiller or just for gralloching/skinning etc? Stand alone framed pull up bar would work for the latter. Easily under £100 and will hold well over 100kg

 

[Rake Aboot]

For outside for skinning and butchering

Needs to fold away flat

 

[wellyboot]

A simple folding gallows type bracket where a pin or bolt on the diagonal brace is removable and it folds flat back on the fence...

what is the fence? Are the posts strong enough to bolt the bracket too and cantilever the weight off it? If not then it would need it's own post concreted in the ground.

 

[wellyboot]

Some 50x50x5 equal angle would be ample for a bracket

 

[Rake Aboot]

No , it’s not for attaching to the fence
I think what I’m after is a swing type frame where the legs fold in to each other

I saw a nice tripod but it was just the metal work for using your own timber and it was a bit dear likes.

 

[sauer]

For skinning roe get a back n decker work mate or lidls middle isle equivalent

The beast sits in gap in middle perfectly,.skin one side down to spine, then other then hang and whip off jacket in second....
My original seen plenty, and worktop top disintegrated after years of cleaning..... replaced with 2x thick polyethylene bits from a big old meat chopping board cut un half

Paul

 

[Rake Aboot]

It’s the hang bit I need

 

[maximus otter]

A rolling clothes rail? Many types available. (This one folds.)

maximus otter

 

[wellyboot]

Some simple keyclamp stuff then maybe.... no specialist tools required. 42.4mm would be ample

 

[Rake Aboot]

Looks good but doesn’t fold flat

 

[Rake Aboot]

A rolling clothes rail? Many types available. (This one folds.)

maximus otter

It’s to be kept outside bud .

 

[Tim.243]

This folds away...@£20.00

 

[SimpleSimon]

Not quite clear from the photos how it fits together, but this might work with a little adaptation?

https://www.smythstoys.com/uk/en-gb/outdoor/swings-and-slides/swings/single-seat-metal-swing-set/p/243387

 

[Klenchblaize]

As someone mentioned, Key-Clamp with lightweight tube would permit constructing what you're looking for and can be deconstructed as much or little as desired depending on the fixtures (clamps) chosen.

Page 2 - 34mm Galvanised Key Clamp Fittings - Interclamp, Q Clamp, Pipeclamp Buy Key Clamps Online https://share.google/V7g4tmWDxngX8ZCW7

K

 

[jall55]

I just use scaffold
Knock 2 poles into the ground
Clamp one across - job done
Takes 2 minutes to do

If you are going to do it in the same spot each time its easy to leave the uprights in place or sink some sleeves in for them